SPEEDWAY 52401 Use and Care Manual download pdf (Page 4)

4

• Air tools and accessories

Do not exceed the pressure rating of

any air tool, spray gun, air

accessories, or inflatables. Excess

pressure can cause them to explode,

resulting in serious injury. Follow the

manufacturer’s recommended

pressure settings for all air tools and

air accessories.

INSTALLATION & LOCATION

Caution: In order to avoid damaging

the air compressor, do not allow the

unit to be tilted from the normal

vertical position when operating.

The compressor must be run with the

rubber feet resting on a flat and

stable horizontal surface.

The air compressor must be used in

a clean and well-ventilated area.The

compressor requires an

unobstructed airflow and must be

located a minimum of 20 inches from

any walls or other obstructions that

may prevent proper ventilation.

Caution: DO NOT place air

compressor in an area:

• Where there is evidence of oil or

gas leaks.

• Where flammable gas vapors or

materials may be present

• Where are temperatures fall below

32°F or exceed 104°F.

• Where extremely dirty air or water

could be drawn into the air

compressor.

WARNING: Serious injury or death

may occur if electrical sparks from

motor and pressure switch come

in contact with flammable vapors,

combustible dust, gases, or

[email protected]

other combustible materials.

When using the air compressor

for spraying paint, place the air

compressor as far away from the

work as possible, using extra

lengths of air hose to extend the

working reach instead of

extension cords.

GROUNDING INSTRUCTIONS

This product should be grounded. In

the event of an electrical short

circuit, grounding reduces the risk

of electric shock by providing an

escape wire for the electric current.

This product is equipped with a cord

having a grounding wire with an

appropriate grounding plug. The

plug must be plugged into an outlet

that is properly installed and

grounded in accordance with all

local codes and ordinances.

DANGER: Improper installation of

the grounding plug can result in a

risk of electric shock. If repair or

replacement of the cord is

necessary, do not connect the

grounding wire to either flat blade

terminal. The wire with GREEN

insulation with or without yellow

stripes is the grounding wire.

This product is for use on a

nominal 120-volt circuit and has a

three-prong grounding plug that

looks like the plug illustrated in

Figure 1. A temporary adapter

similar to the adapter illustrated in

Figure 1-B may be used to

connect this plug to a 2-pole

receptacle as shown in figure 1-B

when a properly grounded outlet

is not available. The temporary

adapter shall be used only until a

properly grounded outlet (Figure

1-A) is installed by a qualified

electrician. Tab for grounding

screw, lug, or similar part

extending from the adapter must

be connected to a permanent

ground such as a properly

grounded outlet box cover.

Whenever the adapter is used, it

must be held in place by a metal

screw.

The use of a GFCI outlet is

strongly recommended. The third

prong is to be used to ground the

tool and provide protection

against electrical shock. Never

remove the third prong.

Check with a qualified electrician

or serviceman if the grounding

instructions are not completely

understood, or if in doubt as to

whether the product is properly

grounded. Do not modify the plug

provided. If it will not fit the outlet,

have the proper outlet installed by

a qualified electrician.

1 2 3 4 5 6 7 8 9 ... 13 14

Comments to this Manuals

No comments